Commercial Grade Quality - Consumer Grade Price!
1-Watt Wireless Amplifier – Power Over Ethernet System!
The RadioLabs Amplifier with POE injector offers great flexibility for installations where long coax cable runs would otherwise be needed. Just run your AP, Router, or Bridge by CAT5 into the POE injector, CAT5 from the injector to the amplifier, and then connect an antenna to the amplifier.
Minimize signal loss! By being able to power the 1-Watt amplifier over CAT5 you only need a short run of cable to connect to the antenna. This not only lowers the cost of an installation, but offers a performance boost by reducing signal loss over coax cable.
It also eliminates the need to put an AP, Router, or Bridge near the Amplifier or Antenna.
In any installation it is important to have fail-safe equipment. This amplifier of the highest quality, manufactured in the US , and is engineered to handle harsh elements. The amplifier and POE units are the simplest and most cost effective solutions for outdoor access point installations without having to worry about cable length.
All Buffalo products currently listed on our site will work with all amplifiers currently listed on our site.
No WiFi amplifier should be used with any wireless device (AP, Router, or Bridge) that has an output of 100mW or more. These units will damage the amplifier and will effectively void any and all warranties. If you need to determine that a product will not put out more power than 100mW please contact the manufacturer.
MADE IN THE USA!
to WiFi Home
View all the WiFi Amplifiers
here to see a hook-up diagram of this Amplifier and POE Injector.
Note: Coaxial cables, APs, Routers, Bridges, and CAT 5 cables are not included. For
cable information, please go here..