WiFi Antenna Coax Connectors – WiFi Cable 

Connectors - WiFi Coax - Cable Crimp style

RadioLabs offers the same, very high quality Coaxial Crimp connectors to our customers, that we use on all our cables.

RadioLabs, offers a full assortment of WiFi connectors. All our WiFi antenna connectors are for specific access points, and provide a low-loss connection to your Home Router, Outdoor Access Point, or Wireless Bridge system.

We offer a full assortment of the following connectors:

  1. RP-SMA Male and Female for RL-LMR-400 and 100 cable
  2. N Male and Female for RL-LMR-400 and 100 cable
  3. RP-TNC Male and Female for RL-LMR-400 and 100 cable
  4. SMA Male and Female for RL-LMR-400 and 100 cable

WiFi Connectors, are the antenna / RF connection, that goes between a WiFi Access Point, Router, Client or other WiFi device with an external antenna, and with the proper WiFi Cable, allows you to install a low loss cable between your WiFi device and your antenna. Cable is very important. Low loss cable minimizes the signal loss, not only on transmit, but more important, on very low receive signal strength incoming. This signal level on the received level, is very low, measured in micro-volts and at the very high frequency microwave signals used in WiFi and wireless communications.

N Male Connector – Wifi – Wireless cable

$4.25

N Male Connector for RL or LMR 400 coax. These rugged connectors are crimp style, ultra low-loss design, incorporating a gold plated pin, crimp ring, and allow for wrench or finger tightening to any coax, or wifi / wireless radio. Perfect for all outdoor applications, which require N Male connection. Works on all RadioLabs WiFi Antennas.

RP-SMA Female – WiFi Coax Connector | 100-400

$4.00$4.25

RP-SMA Connector for RL-LMR-400 and 100 style coax. These high quality, crimp style connectors are the highest quality available, made of solid metal, plated, with gold plated center conductor pin. These connectors are the same style we have used for over a decade, on thousands of customer bridges, omni antennas and almost any imaginable WiFi – Wireless installation.

RP-SMA Male – WiFi Connector for RL-LMR 400 Cable

$4.00$4.25

RadioLabs high quality RP-SMA Male WiFi coaxial connectors, crimp style, for all RL and LMR-400 and 100 series cable. We have installed tens of thousands of these connectors since 2001. They are the most common WiFi connectors on the market, fitting most routers. Install onto any cable with proper crimping tool in seconds. Center solder to tip, or, crimp to tip instantly. We recommend soldering on tip, crimp to braid on outside. Available in single qty, 10 and 100 bulk pack.

Showing all 3 results

1

Start typing and press Enter to search